can not view p2clips in P2CM software

Rami Golan · August 8th, 2008, 11:19 AM

i have upgraded the firmware to version 4.0 on my FS-100 but now i cannot view my clips in the P2 Management Software (version 1.3)

I can see them but they have a little red cross at the top of the thumbnail, when i double click i get the message:

"IT IS NOT PLAYBACK - It was not play back because there was incompleteness in the clip."

Yes that is a cut-n-paste :)

However the clips do play back from the FS-100 back into the HVX200e cam and seem fine. I don't have Premiere to check the files, because i usually send them direct to the editor..

Any thoughts welcome..

August 8th, 2008, 11:19 AM	#1
Rami Golan New Boot Join Date: Feb 2007 Location: SEA Posts: 11	can not view p2clips in P2CM software i have upgraded the firmware to version 4.0 on my FS-100 but now i cannot view my clips in the P2 Management Software (version 1.3) I can see them but they have a little red cross at the top of the thumbnail, when i double click i get the message: "IT IS NOT PLAYBACK - It was not play back because there was incompleteness in the clip." Yes that is a cut-n-paste :) However the clips do play back from the FS-100 back into the HVX200e cam and seem fine. I don't have Premiere to check the files, because i usually send them direct to the editor.. Any thoughts welcome..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode