GoPro 3D to Vegas 10d workflow?
 

Has anyone figured out how to process 3D video from the GoPro 3D camera rig in Vegas 10d? I am new to Vegas and can't seem to get the simplest anaglyph output to work. When I setup the project for Stereoscopic red/cyan anaglyph, dorp the clips on the timeline and render them, I only get output as from a single camera.
Thanks

Re: GoPro 3D to Vegas 10d workflow?
 

Hi
You have to place the L and R clips on your timeline above-below in perfect sync.
After that, select both, right click and choose "Pair as 3D subclip"
One clip disappear, which remain is a 3D subclip now.
You can adjust the alignment, by dropping the new "Stereo 3D adjustment" videofx to that clip.
After editing, hit "file/render as" and render in a format you want. I don't recommend anaglyph, because
of hard color compression, this result lot of ghosting. Instead render to half sidebyside or separate left/right file, and watch with Stereoscopic player.

Oh, don't forget to share your finished clip with us! :-)

I also plan to buy 2 gopro's and the 3D housing for aerial/car shots.
Can you upload a very short sample from the gopro video in native format?
I found just youtube and another compressed videos, but i like to see the original quality
before buying the whole system.

thank you very much
Marton

Re: GoPro 3D to Vegas 10d workflow?
 

Thanks, the pairing was the step I was missing. Is there any way to adjust the vertical alignment of the two clips? My GoPros are aligned well vertically. I can adjust this using the CineForm Software but I would prefer to do all editing in Vegas.

Re: GoPro 3D to Vegas 10d workflow?
 

yes, i wrote it to you:
"You can adjust the alignment, by dropping the new "Stereo 3D adjustment" videofx to that clip."

Vertical, horizonatl, rotation, flipping and even keystone adjustment!
Vegas rocks! :-)

Re: GoPro 3D to Vegas 10d workflow?
 

Thanks again, but I only see horizontal adjustment available with the plugin. How do I get vertical adjustment?

Re: GoPro 3D to Vegas 10d workflow?
 

Hit the triangle next to "corrections"...

Re: GoPro 3D to Vegas 10d workflow?
 

Thanks that did the trick. I will try to post some sample soon.

Re: GoPro 3D to Vegas 10d workflow?
 

Pretch, let's say you needed to get that disappearing right eye back into the timeline to perhaps color correct it or slip the sync a bit, how would you undo that "pair as 3D subclip" proceedure to do that after you had edited with that subclip for a while so it wasn't available as an immediate "undo" ?

Re: GoPro 3D to Vegas 10d workflow?
 

Yes, you cannot "unpair" after pairing, but here is the solution:
when you drop a video fx to a 3D subclip event, and open the FX properties,
you will see TWO checkbox above, next to the fx name.

Why two? One for left stream, one for the right :-)
So you can correct just one view...

Marton

Re: GoPro 3D to Vegas 10d workflow?
 

Well at least that's something. . .