Timecode issue
 

Hey,

I am having a time code issue...
the timecode wont reset after we put in a new hard drive/reel? it start of right after the previews recording...
could not find anything in the manual anybody has a tip?

Re: Timecode issue
 

Shaggy F. - The timecode value on the Ki Pro does not reset when you insert a new Storage Module. This is by design. If you want to change the value, simply enter the CONFIG menu and adjust the TC Value parameter to one of the hour values presented; 01:00:00:00, 02:00:00:00, etc.

If you wish to reset to 01:00:00:00 and that's the value you have been using, you can do this one of two ways. First, use the ADJUST up arrow to go to 02:00:00:00 then ADJUST down to go back to 01:00:00:00. Second, you can also reset any individual parameter back to it's default by holding down the ADJUST up and down buttons at the same time.

Hope this is helpful,
Jon Thorn
Product Manager
AJA Video Systems, Inc.