Hi Everyone

Hope all is well with you all. I have a question for the multiclip now it alls out there. I have 5 cameras that I have used for a concert and have grabbed the footage for a multicam session.

After setting the in points with the only thing I have to sync up with (usually a sound like an applause) I check out the sync of all the 5 clips. Sometimes one or two might be out by about 5 frames or so. Is there anyway I can trim the clip a few frames left or right so it matches up with the other frames from within the multiclip window showing all the clips. Currently, I have to go back to the offening frame in the browser, change the in point of the offending clip and then re make the multiclip. This seems a bit of a long winded way to do it, is changing clips from within multiclip window possible

Thanks

Andy

If any one is interested, I came across the answer whilst surfing the net.

To make a slight change to an individual clip in a multicam set up

click on file to select
press and hold - ctrl and shift
move the mouse over the footage you want to change
click and move left or right to move footage start and end point

Thanks, didn't know that either. I'll give it a try.