Good evening,

Was wondering if projects and files can be transferred back and forth between neo and 5.0.

dale

thanks

Good evening,

Was wondering if projects and files can be transferred back and forth between neo and 5.0.

dale

thanks

Dale - I had the same question and sent off to Edius Tech support: The response was as long as you DON'T apply any features from Edius 5 that aren't available in Neo 2/2.5 booster, you can interchange back and forth. Neo 2/2.5 Booster would be a good for the basic cutting, then bring into Edius 5.1x-5.5 for grading/finishing.

The only sure way to verify is to have two computers with one of each NLE and test for yourself with an external hard drive with a test project.

Cliff is correct...you can switch them.