DV Info Net

DV Info Net (https://www.dvinfo.net/forum/)
-   Canon XH Series HDV Camcorders (https://www.dvinfo.net/forum/canon-xh-series-hdv-camcorders/)
-   -   Merlin with XH-A1 (https://www.dvinfo.net/forum/canon-xh-series-hdv-camcorders/478158-merlin-xh-a1.html)

Greg Clark May 5th, 2010 09:48 AM

Merlin with XH-A1
 
There has to be an easier way? I am trying to place the camera on the stage at -1 so I can use the G screw. I spent an hour trying to balance the rig and still no luck. I am quite sure I am making my error using the trim incorrectly.
Any advice would be greatly appreciated.

Bill Engeler May 5th, 2010 10:54 AM

The I hole should work better. You can check out some other settings here: Welcome to Tiffen - Steadicam Merlin Cookbook Settings

I'm not near my gear now, so I can't tell you my exact settings, but 5 mid weights and one start weight on the bottom, and one finish on the front should get you going. Open the arm all the way.

Greg Clark May 8th, 2010 06:38 AM

Thanks Bill. Following your instructions I had a wonderful two hours with the Merlin and my XH-A1.
I now have a sore shoulder but this will pass.

Morgan Cox May 8th, 2010 06:47 AM

Quote:

Originally Posted by Bill Engeler (Post 1523512)
The I hole should work better. You can check out some other settings here: Welcome to Tiffen - Steadicam Merlin Cookbook Settings

But 5 mid weights and one start weight on the bottom, and one finish on the front should get you going. Open the arm all the way.

This has worked great for me. Here is my sample using that setup. A lot of practice is needed



All times are GMT -6. The time now is 04:01 AM.

DV Info Net -- Real Names, Real People, Real Info!
1998-2024 The Digital Video Information Network