Problem after updating firmware to latest release
I have been using an old firmware (1.0.1xx) and recently updated with the intermediate one (1.1.0) and then update to the latest one, .151
However after upgarding that, there is a error message appear "err checking opt: 00" on the LCD. recording is fine as well as the triggering so far.. been doing some test and see if i have any sorts of video or audio problem problem happening at this moment is the timecode will not run on the LCD during recording... (no matter is from LTC or internal generated) please advise. cohen |
It is my understanding that you should have upgraded to 1.0.64 before installing the latest firmware. 1.0.64 was a big mandatory firmware update that all nanoflashes must have.
|
im using XDR instead.
I do follow the instruction regards to older firmware, it must have the intermediate firmware update, i.e. 1.1.0 installed first, which I've did. and then i've updated the XDR to the latest firmware, and now having the mentioned problem from above on my thread. please advise. many thanks cohen |
Firmware this and thats
Quote:
|
Dear Friends,
If updating from 1.0.141 or older version (see System->About), the intermediate update 1.1.0 is required first before updating. Dear Cohen, Since you are having problems, may I suggest that you reload firmware 1.1.63, then re-install 1.1.151. I will also send you a private message with all of my contact information. |
All times are GMT -6. The time now is 09:14 AM. |
DV Info Net -- Real Names, Real People, Real Info!
1998-2024 The Digital Video Information Network