DV Info Net

DV Info Net (https://www.dvinfo.net/forum/)
-   Convergent Design Odyssey (https://www.dvinfo.net/forum/convergent-design-odyssey/)
-   -   Using a nanoFlash as HDMI to SDI Converter (https://www.dvinfo.net/forum/convergent-design-odyssey/493659-using-nanoflash-hdmi-sdi-converter.html)

Steve Kalle March 26th, 2011 10:41 PM

Using a nanoFlash as HDMI to SDI Converter
 
Will my nanoFlash allow me to send the HDMI signal from a cableTV box through to the HD-SDI out? If so, is "E to E" the correct setting or is it something else?

I need to check the video levels from our tv channel using the waveform in our Panasonic 17" broadcast monitor to see if Comcast is distorting the image.

Also, with a NTSC (486i) input via SDI into the nanoFlash, will its HDMI output anything?

Thanks

Dan Keaton March 27th, 2011 07:08 AM

Re: Using a nanoFlash as HDMI to SDI Converter
 
Dear Steve,

The nanoFlash can be used as a HDMI to HD-SDI converter.

However, if the "Broadcast Flag" is set, then the nanoFlash is prevented, by law, from accepting the footage.

Yes, you can use E to E Direct, or leave it off, this is your call.

The nanoFlash will not output SD material via the HDMI output, just the HD-SDI output.

Steve, you may call me at any time.

My phone numbers are listed at the bottom of this link:

Support Contacts | Convergent Design

Dave Sperling March 27th, 2011 09:44 AM

Re: Using a nanoFlash as HDMI to SDI Converter
 
Dan,
Haven't tried it, so I'm just asking --
When you say NanoFlash won't accept footage if broadcast flag is on, does that mean that it shows no input (or shows input but won't convert output), or does it mean that in E-E the picture will go through but that it can't record?
Just wondering.
-Dave S

Dan Keaton March 27th, 2011 10:32 AM

Re: Using a nanoFlash as HDMI to SDI Converter
 
Dear Dave,

By law, if the Broadcast Flag is on, we are not allowed to accept the signal.

Thus, it is as if there is no signal connected to the nanoFlash.

Thus, the nanoFlash will not process any signal if this Broadcast Flag is on, which means that the content is copy protected.

There is a reasonable chance that your cable box will not have the Broadcast Flash on.

Certain devices just turn this flag on and leave it on.

Jack Zhang April 1st, 2011 04:10 PM

Re: Using a nanoFlash as HDMI to SDI Converter
 
The Broadcast Flag is also known as HDCP. All consumer devices with HDMI (with the exception of camcorders and the XBOX 360 when not playing DVDs) are required to protect their outputs.


All times are GMT -6. The time now is 10:39 PM.

DV Info Net -- Real Names, Real People, Real Info!
1998-2024 The Digital Video Information Network