ULead DVD Workshop Question
 

So I'm working on a wedding video. I finished editing with Premiere Pro, ecoded it to mpeg 2 with my Matrox card. Everything fine so far.

I come to the conclusion that it will not fit on one disc. I put the first 1:48 on the first and it went fine. Everything looks and sounds decent.

After finishing that step, I went back to the edit section and tried to set a new IN point, right where I left off. I only want to burn what didn't fit on the first disc.

My problem is that the sound now is not synced. If I return the IN point to the beginning, it's fine, but when I move it, the pictures are start where I move the IN point, but the sound begins at the start of the video.

Anyone know what I'm doing wrong?

Or am I going to have to go back into Premeire and encode a separate section. I know I could do this, but it seems much easier to address the ULead Problem.

Which version of DVD Workshop are you using?
Have you applied the latest patches?

Thanks for the link to the patches. I should have looked there first.

The problem is, even after downloading, installing, rebooting, it had no effect at all.

I move the set it mark and the audio always starts at the beginning instead of where it should. It's very maddening.