Jason R. Wood
June 30th, 2004, 06:27 PM
Hello,
We're having problems outputing VIA firewire to our Sony VX1000 and to our Canopus ADVC 100.
The video plays back choppy and the audio jumps.
We're able to edit just fine, however when we go to dump to tape ... we run in to the above mentioned problems.
I'm assuming it's just a setting we've negelected to set, but I'm not entirely sure.
System specs:
Power PC G4 (2.1)
OSX 3.3.4
933 mh
1 gig ram
Bus Speed 133
Also, on a side not, is there a way where we can set a default option so FCP opens to a new blank project as oppose to opening to the most previous project worked on.
Thank you.
We're having problems outputing VIA firewire to our Sony VX1000 and to our Canopus ADVC 100.
The video plays back choppy and the audio jumps.
We're able to edit just fine, however when we go to dump to tape ... we run in to the above mentioned problems.
I'm assuming it's just a setting we've negelected to set, but I'm not entirely sure.
System specs:
Power PC G4 (2.1)
OSX 3.3.4
933 mh
1 gig ram
Bus Speed 133
Also, on a side not, is there a way where we can set a default option so FCP opens to a new blank project as oppose to opening to the most previous project worked on.
Thank you.