New to the nanoFlash scene, and just got around to manually setting my timecode internally.

In it's current state, internal timecode setting requires you to move up and down groups of digits, not each digit one by one.

Can this be changed to individual digits in a future firmware upgrade?

Dear Jack,

I will present your request to our engineers.

Please note that you can hold down the up or down buttons and it will start advancing quickly through the numbers after a short delay.

I realize that, still, individual digits could speed timecode setting up when you're forced to use internal timecode generators.

I shoot rec run internal TC and its much easier than with tapes.. I set it to start at 01hrs and then leave it all day (s) long .. much easier than changing TC for each tape.. change per job only :)