Frank Pietrantoni
February 14th, 2006, 08:34 PM
Hey all,
I just ordered/recieved a new Delvcam 5.6 LCD. I hooked it up to my PD170 using an RCA to mini cable, and then set the cam's display to V-OUT/LCD.
I powered up the Delvcam, but there is no display at all...not even any shadowing when cranking up/down brightness and contrast controls.
I also noticed that the screen flashes and then goes dark, but the power LED stays on.
I think this may be a dumb question but...do you think this is a defective unit, or is my cable configuration at fault? Any thoughts are appreciated. Thanks.
I just ordered/recieved a new Delvcam 5.6 LCD. I hooked it up to my PD170 using an RCA to mini cable, and then set the cam's display to V-OUT/LCD.
I powered up the Delvcam, but there is no display at all...not even any shadowing when cranking up/down brightness and contrast controls.
I also noticed that the screen flashes and then goes dark, but the power LED stays on.
I think this may be a dumb question but...do you think this is a defective unit, or is my cable configuration at fault? Any thoughts are appreciated. Thanks.