|
View Full Version : How much can I mount on my XL2 Bryan Aycock April 22nd, 2006, 07:09 PM My shooting conditions require an Anton Bauer battery mount, an on-camera light, and an on-camera wireless audio receiver. If the battery mount attaches to the shoulder pad, and the on camera light attaches to the accessory shoe, whare can I mount my wireless receiver? Tom Wills April 22nd, 2006, 07:22 PM Velcro it to somewhere. Tape deck door maybe? That's the easy solution. Wireless recievers aren't heavy. I've seen a few setups that are setup like this too. Also, this should be in the XL2 area. Maybe some kind op can move it on over there. Hart Boyd April 22nd, 2006, 07:30 PM If you are using a Anton Bauer battery then you must be using the 'Anton Bauer QRXL12 Gold Mount". From there you can add the "Anton Bauer ABWM-KIT Universal Wireless Mounting Plate Kit" and that will allow you to mount a wireless reveiver box to it. My Shure UP-4 wireless kits came with a mounting box each so all I needed was the bracket and then I piggyback both boxes. The bracket http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=132810&is=REG&addedTroughType=categoryNavigation and (sample box) http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=286995&is=REG&addedTroughType=categoryNavigation Greg Boston April 22nd, 2006, 10:33 PM I am relocating this thread to the XL2 forum. regards, -gb- Andrew Khalil April 23rd, 2006, 05:56 AM I've had good luck mounting a Sennheiser G2 receiver between the accessory mount and the camera handle on that little piece at the top that anchors the mount to the camera (with the whole in it) - the receiver fits perfectly in there with a bit of velcro. Patrick King April 23rd, 2006, 08:14 AM Another option here (http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=284436&is=REG&addedTroughType=categoryNavigation), same idea but made specifically for the XL2. This one (http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=325272&is=REG&addedTroughType=categoryNavigation) is made specifically for Senn G wirelles mounting. Miguel Lombana April 23rd, 2006, 10:34 AM Another option here (http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=284436&is=REG&addedTroughType=categoryNavigation), same idea but made specifically for the XL2. This one (http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=325272&is=REG&addedTroughType=categoryNavigation) is made specifically for Senn G wirelles mounting. Cool find, just ordered one... neat stuff. |