David Scattergood
February 6th, 2007, 05:24 AM
Hi,
I've had a good route through the help manual and google etc but cannot seem to pin point an answer to my current issue. (I'm also following the DVD FCP Suite guide which is helping up to this point at least).
I'm trying to export a clip from FCP to motion via the Send to - Motion Project - Save As - Embed Motion Content.
My problem lies with the fact that as soon as I send to Motion the clip loses it's anamorphic ratio - it becomes 4:3. I actually noticed this once I'd finished editing with motion, but doing the same routine again proves that this is 'switched' immediately as the clip is sent to motion. I've had a look at the media tab in motion and the aspect ratio is the same (720 x 480...I should really be running the PAL version but the training files seemed to push me onto NTSC for some reason???). Unchecked/checked the 'Correct for Aspect Ration' tab to little avail.
Anything look amiss here folks?
Many thanks.
I've had a good route through the help manual and google etc but cannot seem to pin point an answer to my current issue. (I'm also following the DVD FCP Suite guide which is helping up to this point at least).
I'm trying to export a clip from FCP to motion via the Send to - Motion Project - Save As - Embed Motion Content.
My problem lies with the fact that as soon as I send to Motion the clip loses it's anamorphic ratio - it becomes 4:3. I actually noticed this once I'd finished editing with motion, but doing the same routine again proves that this is 'switched' immediately as the clip is sent to motion. I've had a look at the media tab in motion and the aspect ratio is the same (720 x 480...I should really be running the PAL version but the training files seemed to push me onto NTSC for some reason???). Unchecked/checked the 'Correct for Aspect Ration' tab to little avail.
Anything look amiss here folks?
Many thanks.