<<<-- Originally posted by Cosmin Rotaru : Hi Charles,
Hi Charles,

The piece "foreandaftadjustments3" - the U shaped part is tight with two screws on the rectangular shape. Maybe you could make the rectangular piece a bit rounded where it gets in touch with the U shaped piece. Or the U shaped part coul be rounded or just a litle V shaped on that edge. Or just insert some kind of balancing... thing, between the two parts, in the midle of the distance between the two screws... You'll than use the two screws to adjust the arm in the other plan?-->>>


Wanna do a little diagram to help me understand your idea?



<<<--The screws seems to be to close one to the other, though,
You have two adjusting screws on one side. What about the other side? -->>>

Not really necessary. I thought the same thing too but when I tested it as it is it seemed to work any way. But I'm still testing it a little just to be sure.


It seems to me that the screw used for the pivoting is getting some headache in there :) What metric is that particular screw? I hope is strong enough!

<<<-- Anyway, is looking verry good. I'm already used to see this kind of work from you! -->>>

Thanks for the vote of confidence.

Hi Charles,

I have e-mailed you a small diagram. I'd have liked to link it here so others could see it and maybe contribute with other solutions or just share a thought... Unfortunately, I have some problems with the ftp right now...

Maybe by now you already figured out a better solution!