Jim Froom
May 29th, 2008, 08:06 PM
Just spent 1 1/2 days working with my A1 with 35 Adapter and matching it to a HV20. Haven't used camera in about 60 day, but it's pretty new with few hours on it. Camera was on all day today and part of the day yesterday.
Decided to hook up some Mic's to the XLR ports which I use all the time. Can't get any levels.
Tried the line in, no audio. Xlr's, no audio.
On board mike works.
Anyone have a suggestion.
I use phantom power, (both mic's and cables work through my mixer), have tested with all switches (that I remember) on and off.
Can't get any response on the levels.
I ran this camera less than 20 hours before I had to send it back for a firewire repair. It hasn't been run 10 hours since I got it back. Feeling a little unlucky right now.
Hoping I'm missing something, but I'm guessing it's broke and has to go back. Went through every page in the manual, found nothing. I keep hoping I'm missing something obvious.
Anybody know of any gotcha's regarding some switch or software setting I'm missing.
thanks in advance.....
Decided to hook up some Mic's to the XLR ports which I use all the time. Can't get any levels.
Tried the line in, no audio. Xlr's, no audio.
On board mike works.
Anyone have a suggestion.
I use phantom power, (both mic's and cables work through my mixer), have tested with all switches (that I remember) on and off.
Can't get any response on the levels.
I ran this camera less than 20 hours before I had to send it back for a firewire repair. It hasn't been run 10 hours since I got it back. Feeling a little unlucky right now.
Hoping I'm missing something, but I'm guessing it's broke and has to go back. Went through every page in the manual, found nothing. I keep hoping I'm missing something obvious.
Anybody know of any gotcha's regarding some switch or software setting I'm missing.
thanks in advance.....