Ramji Meena
November 2nd, 2009, 05:03 AM
I have ordered 75 ohm Neutrik made BNC connectors with Belden 1505A cable to connect my Nanoflash HD-SDI with EX3. Will it be a good choice?
Ramji
Ramji
|
View Full Version : Good Connector for Nanoflash and PMW EX3 Ramji Meena November 2nd, 2009, 05:03 AM I have ordered 75 ohm Neutrik made BNC connectors with Belden 1505A cable to connect my Nanoflash HD-SDI with EX3. Will it be a good choice? Ramji Bruce Rawlings November 2nd, 2009, 05:13 AM Have you ordered two cables? always have a spare. Paul Cronin November 2nd, 2009, 07:39 AM I would go here and post a question to Dan, Convergent Design Flash XDR - The Digital Video Information Network (http://www.dvinfo.net/forum/convergent-design-flash-xdr/) Shawn Dooling November 3rd, 2009, 03:15 PM I would go here and post a question to Dan, Convergent Design Flash XDR - The Digital Video Information Network (http://www.dvinfo.net/forum/convergent-design-flash-xdr/) Paul, that link doesn't work.. i get "invalid Forum specified. If you followed a valid link, please notify the administrator" David Issko November 3rd, 2009, 03:22 PM I have ordered 75 ohm Neutrik made BNC connectors with Belden 1505A cable to connect my Nanoflash HD-SDI with EX3. Will it be a good choice? Ramji Yes it will. The cable is a RG-59U 75ohm impedance cable. For ease of not getting cables tangled, keep the cable as short as practical. I have my nf mounted on the rear shoe of the EX3 so my coax cable is quite short but without stressing the cable & connectors. Boots at each end will assist. Looks neat that way as well. |