Byron Huskey
February 13th, 2007, 03:02 AM
Hey all, small, but deadly problem:
I have a 3 minute short I'm attempting to export from FCP. The original is in 24P (from a canon xh-a1) and I'm using Quicktime Conversion to export it. The problem is that the beginning of the clip (after the short title) is skipping a few times, much like an old record player that repeats a few notes over.
It only does it for the first 20 seconds or so, out of the 3 minutes, so I'm not sure what's going on. It plays perfectly in the time line, but 3 different exports (two .movs and a mpeg4 at different sizes) all produced the same error in the same spots. I tried moving the clip around up a track on the time line, which had the effect of changing when and how often it skipped, but again only in the same general time frame. I'm at a complete loss as to why it would have a problem in the first place, let alone this section.
Any thoughts?
(Btw, I'm using FCP 5.1.2 and I would use Compressor, but I'm experiencing that "cannot connect to source" error AGAIN, so I'm just going to wait a little bit to get that sorted)
I have a 3 minute short I'm attempting to export from FCP. The original is in 24P (from a canon xh-a1) and I'm using Quicktime Conversion to export it. The problem is that the beginning of the clip (after the short title) is skipping a few times, much like an old record player that repeats a few notes over.
It only does it for the first 20 seconds or so, out of the 3 minutes, so I'm not sure what's going on. It plays perfectly in the time line, but 3 different exports (two .movs and a mpeg4 at different sizes) all produced the same error in the same spots. I tried moving the clip around up a track on the time line, which had the effect of changing when and how often it skipped, but again only in the same general time frame. I'm at a complete loss as to why it would have a problem in the first place, let alone this section.
Any thoughts?
(Btw, I'm using FCP 5.1.2 and I would use Compressor, but I'm experiencing that "cannot connect to source" error AGAIN, so I'm just going to wait a little bit to get that sorted)