Capture ?

[Gary Harper]

When using Scene Detect Capture mode with my JVC100HD as source device, and selecting to capture entire tape #1, it works fine, however when inserting tape #2 and Renaming Tape etc. it will roll the camera but not capture any media. When I give it an IN and Out point it will work fine. Anyone have an idea why this happens? Should I exit capture before inserting Tape #2, etc.?
Also when Setting Up for a new project, I have noticed that a Cineform Window pops up. Should I be attached to the internet for some capture up date or action to occure?

Thanks,

Gary

[Alex Horvath]

Originally Posted by Gary Harper

When using Scene Detect Capture mode with my JVC100HD as source device, and selecting to capture entire tape #1, it works fine, however when inserting tape #2 and Renaming Tape etc. it will roll the camera but not capture any media. When I give it an IN and Out point it will work fine. Anyone have an idea why this happens? Should I exit capture before inserting Tape #2, etc.? Gary

Yes, happens to me too with ppro1.51. Just close ppro after each cassette and reopen and it works again...

Originally Posted by Gary Harper

Also when Setting Up for a new project, I have noticed that a Cineform Window pops up. Should I be attached to the internet for some capture up date or action to occure?

No, just a splashscreen.

alex

[Gary Harper]

Thanks Alex. It's Just amazing... I have no less than 5 PPro Manuals and not them or even the PPro web sight mentions this situation.
Gary